FEATURES / PERFORMANCE
Question: How long does Fusion Pro™ need to cure before it can be exposed to water?
Answer: Fusion Pro needs three days to dry before it can be exposed to water.
Question: Is Fusion Pro a urethane grout or a premix?
Answer: No. Fusion Pro is an advanced acrylic plus silicone resin and is a Single Component Grout™.
Question: What is Microban
®
and what does it do for my grout?
Answer: Microban is a widely recognized antimicrobial additive made by the Microban Products Company that is
included in Fusion Pro. Microban inhibits the growth of stain causing mold and mildew on dried grout.
Question: Can Fusion Pro be exposed to extremely high temperatures?
Answer: Fusion Pro can be used in normal tile installations. It performs similarly to epoxy and urethane grouts relative
to heat. It is safe to steam clean and pressure wash floors grouted with Fusion Pro.
Question: How many colors are available?
Answer: Custom Building Products
®
offers Fusion Pro in 24 colors.
INSTALLATION
Question: When can Fusion Pro be exposed to traffic?
Answer: Fusion Pro can be exposed to light foot traffic after 24 hours. For heavy foot traffic allow at least 72 hours.
Question: How long does it take for Fusion Pro to fully cure?
Answer: Fusion Pro develops its hardness in typical installation environments over seven days. At the end of three
days, Fusion Pro and cement grouts demonstrate a similar hardness. At the end of seven days, full hardness
is achieved.
Question: At what temperature can Fusion Pro be installed?
Answer: Fusion Pro is designed to be installed at temperatures between 50°F and 90°F.
Question: Can Fusion Pro be installed outdoors in inclement weather?
Answer: If inclement weather is expected, protect the area where Fusion Pro is being or has been installed. To
guard against rain or moisture, tent the area at least 12 inches above the floor.
Question: Is Fusion Pro difficult to clean after installations like epoxy and urethane grouts?
Answer: No. Fusion Pro is as easy to clean up with an effort level similar to cement grouts. Unlike other grout
products, you can start cleaning immediately after grouting with Fusion Pro.
Question: Can Fusion Pro be covered on a job site once applied?
Answer: Fusion Pro can be covered on a jobsite, but it must be done with breathable craft paper or a similar
breathable material. Fusion Pro cures by evaporation so any covering may increase the time needed to
cure and the use of non-breathable coverings may halt the curing process.
Question: How will temperature and humidity impact curing time for Fusion Pro?
Answer: Fusion Pro cures by evaporation. Warmer and drier weather will decrease the amount of time needed
for cure whereas cooler and more humid environments will extend the cure time.
Question: What is the coverage for Fusion Pro?
Answer: Please refer to our Fusion Pro coverage chart online at www.custombuildingproducts.com.
Question: I noticed some grout haze on my tile the day after install. How do I remove this?
Answer: Grout haze is easily cleaned up with Aqua Mix
®
Grout Haze Clean-Up. For tile and stone sensitive to acid,
test the product prior to application.
Question: Do I need any cleaning additive to my wash water when installing Fusion Pro?
Answer: No. Cleaning additives are not required or recommended for your initial and final clean. Custom Building
Products discourages the use of any additives in the rinse water as they may inhibit with the curing process.
FAQFP 8/12R BH
(1 paginas)
(4 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales